Delta DVP-ES3 Series, Руководство по эксплуатации

Страница: 211 / 411

C h a p t e r 8 H a r d w a r e C o n f i g u r a t i o n
8 - 7
8_
System Parameter
On the System Parameter page, you can set parameters by entering appropriate values or by selecting from a list.

Clear Non-latched area when Run

Stop
This determines whether the states and values of the non-latched devices are cleared when the PLC changes
from Run to Stop.

Disable: all the states and values in the non-latched devices stay the same.

Enable: all the states and values in the non-latched devices are cleared and restored to defaults.

Y keeps outputting when RUN

Stop
This determines the states of the Y devices when the CPU module begins to run or stop.

Off: all Y devices are set to OFF.

Retain: the states of the Y devices stay the same.

Setting delay time to detect I/O Module
This sets the time to detect an I/O module after powering on the CPU module.

Assign X Input Point Control Run/Stop
This assigns an input point to have the CPU module run or stop.

Disable : run or stop the CPU module with the dip switch of the CPU module.

Enable : run or stop the CPU module with the assigned input point, and the dip switch of the CPU module still
controls the run stop state of the CPU module.