Turbo PMAC Clipper Hardware Reference Manual
Connections and Software Setup
39
Note
The direction of the input and output lines on this connector are
set by jumpers E14 and E15.
If E14 is removed or E15 is installed then the multiplexing
feature of the JTHW port cannot be used.
26-pin female flat cable connector T&B Ansley P/N 609-2641
Standard flat cable stranded 26-wire T&B Ansley P/N 171.26
Phoenix varioface module type FLKM 26 (male pins) P/N 22 81 05 0
Thumbwheel Port Digital Inputs and Outputs
The inputs and outputs on the thumbwheel multiplexer port J8 may be used as discrete, non-multiplexed
I/O. In this case, these I/O lines can be accessed through M-variables:
M40->Y:$78402,8,1
; SEL0 Output
M41->Y:$78402,9,1
; SEL1 Output
M42->Y:$78402,10,1
; SEL2 Output
M43->Y:$78402,11,1
; SEL3 Output
M44->Y:$78402,12,1
; SEL4 Output
M45->Y:$78402,13,1
; SEL5 Output
M46->Y:$78402,14,1
; SEL6 Output
M47->Y:$78402,15,1
; SEL7 Output
M48->Y:$78402,8,8,U
; SEL0-7 Outputs treated as a byte
M50->Y:$78402,0,1
; DAT0 Input
M51->Y:$78402,1,1
; DAT1 Input
M52->Y:$78402,2,1
; DAT2 Input
M53->Y:$78402,3,1
; DAT3 Input
M54->Y:$78402,4,1
; DAT4 Input
M55->Y:$78402,5,1
; DAT5 Input
M56->Y:$78402,6,1
; DAT6 Input
M57->Y:$78402,7,1
; DAT7 Input
M58->Y:$78402,0,8,U
; DAT0-7 Inputs treated as a byte
Содержание Turbo PMAC Clipper
