Turbo PMAC Clipper Hardware Reference Manual
Appendix A
76
Version 101 and lower
Jumper
Configuration
Default
E5:
1
2
3
Factory use only. The board will not communicate via
Ethernet unless jumper is installed on pins 1 to 2
1 – 2
E6: ADC Inputs Enable
Jumper
Configuration
Default
E6:
1
2
1 to 2 to enable the Option-12 ADC inputs
Remove jumper to disable the ADC inputs, which is
necessary for reading current feedback signals from digital
amplifiers
Factory
Set
E7
– E8: USB/Ethernet Reset Jumpers
Jumper
Configuration
Default
E7:
1
2
Factory use only. Install E7 for normal operation
1 – 2
E8:
1
2
Install E8 to reload communication Boot/Firmware, or
change IP Address
Remove E8 to enable write protection for normal
operation
Factory
Set
E10
– E12: Flash IC Jumpers
Jumper
Configuration
Default
E10:
1
2
Remove E10 to read flash IC on power up/reset
Factory
Set
E11:
1
2
1 to 2 to read flash IC on power up/reset
Factory
Set
E12:
1
2
1 to 2 to read flash IC on power up/reset
Factory
Set
Содержание Turbo PMAC Clipper
