Dell PowerEdge R740xd, Инструкция по установке и обслуживанию

Страница: 192 / 210

WARNING: To protect the power supply from electrostatic discharge, the captive screws must be covered with the
rubber cap before inserting the mating connector into the power supply.
3 Rotate the rubber cap clockwise to fix it over the captive screws.
4 Insert the mating connector into the power supply.
System board
A system board (also known as the motherboard) is the main printed circuit board in the system with different connectors used to connect
different components or peripherals of the system. A system board provides the electrical connections to the components in the system to
communicate.
Removing system board
Prerequisites
CAUTION: If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to create a
recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this system
board, you must supply the recovery key when you restart your system or program before you can access the encrypted data on
your drives.
CAUTION: Do not attempt to remove the TPM plug-in module from the system board. Once the TPM plug-in module is installed,
it is cryptographically bound to that specific system board. Any attempt to remove an installed TPM plug-in module breaks the
cryptographic binding, and it cannot be re-installed or installed on another system board.
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in Before working inside your system .
3 Remove the following:
a
Air shroud
b Cooling fan assembly
c Rear drive cage (if applicable)
d Mid drive tray (if applicable)
e Power supply unit(s)
f All expansion card risers
g Integrated storage controller card
h iDSDM/vFlash card
i Internal USB key (if applicable)
j Processor and heat sink module
k Processors and DIMM blank
CAUTION: To prevent damage to the processor pins when replacing a faulty system board, ensure that you
cover the processor socket with the processor protective cap.
l Memory modules and memory module blanks
m Network daughter card
Steps
1 Disconnect all cables from the system board.
CAUTION: Take care not to damage the system identification button while removing the system board from the chassis.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
2 Holding the system board holder, pull the blue release pin, lift the system board, and then slide it toward the front of the chassis.
Sliding the system board toward the front of the chassis disengages the connectors from the back of the chassis slots.
3 Lift the system board out of the chassis.
192 Installing and removing system components