1
Follow the safety guidelines listed in the Safety instructions section.
2
Follow the procedure listed in the Before working inside your system section.
3
Remove the cooling shroud.
NOTE:
If applicable, close the expansion card latch on the cooling shroud to release the full length card.
4
If applicable, disconnect the cables from expansion card (s).
5
If applicable, remove the expansion card riser
6
Keep the Phillips #2 screwdriver ready.
Steps
1
Align and insert the tabs on the iDRAC ports card on the slots on the chassis wall.
2
Insert the iDRAC ports card into the connector on the system board.
3
Tighten the screws to secure the iDRAC ports card.
Figure 48. Installing the iDRAC ports card
1
iDRAC ports card holder
2
iDRAC ports card
3
iDRAC port
4
SD vFlash media card reader
5
screws (2)
6
iDRAC ports card connector on system board
Next steps
1
If removed, reinstall the PCIe expansion card riser.
2
If disconnected, connect the cables to the expansion card(s).
3
Reinstall the cooling shroud.
4
If required, open the expansion card latch on the cooling shroud to secure the full length expansion card.
5
Follow the procedure listed in the After working inside your system section.
108
Installing and removing system components
