Dell PowerConnect W-IAP3WN, Руководство пользователя

Страница: 79 / 246

Dell PowerConnect W-Series Instant Access Point 6.1.3.4-3.1.0.0
| User Guide Managing IAPs |
79
Adding an IAP to the Network
To add an IAP to the Dell Instant network, assign an IP address. For more information, see “Assigning an IP
Address to the IAP” on page 14 .
After an IAP is connected to the network, if the Auto Join Mode feature is enabled, it is listed in the Access Points
tab in the Instant UI. The IAP inherits the configuration and image from the Virtual Controller.
If the Auto Join Mode is not enabled, then perform the following steps to add an IAP to the network:
1. In the Access Points tab, click the New link.
Figure 62
Adding an IAP to the Instant Network
2. In the New Access Point window, enter the MAC address for the new IAP.
Figure 63
Entering the MAC Address for the New IAP
3. Click OK.
Removing an IAP from the Network
An IAP can be manually removed from the network only if the Auto Join Mode feature is disabled. To manually
remove an IAP from the network:
1. In the Access Points tab, click the IAP which you want to delete. An x appears against the IAP.
2. Click x to confirm the deletion.
Warning Warning messages.
Notice Significant events of a non-critical and normal nature.
Informational Messages of general interest to system users.
Debug Messages containing information useful for debugging.
Table 12
Logging Levels
Logging Level Description
NOTE:
The deleted IAP(s) cannot join the Instant network anymore and no longer appears in the WebUI. However, the master IAP
cannot be deleted from the Virtual Controller.