3. Insert the expansion card into the expansion-card connector.
If the expansion card is full-length, insert the front end of the card into the corresponding card guide on the inside front of the chassis as you
insert the card into its connector. Insert the card's edge connector firmly into the expansion-card slot.
4. When the card is firmly seated in the connector, secure the card's mounting bracket to the chassis with the screw you removed in
step 2
.
5. Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
6.
Replace the computer cover
and
reset the chassis intrusion detector
.
Memory
To remove a Rambus in-line memory module (RIMM), perform the following steps:
1.
Remove the computer cover
.
2.
Remove the system power supply
to allow you to access the RIMMs.
3. Press the securing clips outward simultaneously until the RIMM disengages and pops out slightly from the socket (see Figure 22).
Figure 22. Removing a RIMM
To reinstall a RIMM, perform the following steps:
1. Locate the plastic securing clips at each end of the socket (see
Figure 23
).
2. Press the clips outward until they snap open.
3. Press the RIMM straight into the slot running down the center of the socket until the securing tabs snap into place around the ends of the
RIMM.
4.
Replace the computer cover
and
reset the chassis intrusion detector
.
Figure 23. Installing a RIMM
1
Filler bracket
1
Securing clips (2)
