Dell EMC VxFlex Ready Node 13G, Руководство пользователя

Страница: 19 / 84

l
Enable IP IPv4 = Enabled
l
Enable DHCP = Disabled
l
Static IP Address = Static IP address
l
Static Gateway = Gateway IP address
l
Static Subnet Mask = Subnet mask IP address
d. From the IPv6 Settings pane, configure the IPv6 parameter values for the
BMC (iDRAC) port.
e. From the IPMI Settings pane, verify the following parameter values:
l
Enable IPMI Over LAN = Enabled
l
Channel Privilege Level Limit = Administrator
f. If you are working in a VLAN setup, access the VLAN Configuration pane
and configure the VLAN ID parameters.
g. When the parameter set up is complete, click Back to display the iDRAC
Settings screen.
5. From the iDRAC Settings screen, click Finish, Yes, and then OK to return to
the System Setup Main Menu screen.
6. In the System Setup Main Menu screen, select the System BIOS menu.
7. In the System BIOS Settings screen, verify that the processor settings are
correct.
If the settings are incorrect, configure them as follows:
a. Select Processor Settings.
b. In the System BIOS Settings--Processor Settings pane, verify the
following parameter values:
l
Virtualization Technology = Enabled
l
Number of Cores Per Processor = All
c. Click Back to return to the System BIOS Settings screen.
8. Configure boot settings,:
a. Select Boot Settings.
b. In the System Boot Settings--Boot Settings pane, verify that Boot Mode
is set to BIOS.
c. Select the BIOS Boot Settings link.
d. In the System BIOS Settings--Boot Settings--BIOS Boot Settings pane,
verify that:
l
In the Boot Sequence list, Hard drive C: appears as the first item.
l
In the Hard-Disk Drive Sequence list, the SATADOM-ML 3SE device
appears as the first item.
e. Click Back twice to return to the System BIOS Settings screen.
9. Configure integrated devices:
a. Select Integrated Devices.
The System BIOS Settings--Integrated Devices screen appears.
Configuring the Hardware
Set up the BMC (iDRAC) IP address and BIOS 19