Dell E1705 - Inspiron Laptop, Руководство пользователя

Страница: 97 / 188

Troubleshooting
97
S
EEK ERROR
—
The operating system cannot find a specific track on the hard drive.
S
HUTDOWN FAILURE
—
A chip on the system board may be malfunctioning. Run the System Set tests in
the Dell Diagnostics. See "Dell Diagnostics" on page 87.
T IME - OF - DAY CLOCK LOST POWER —
System configuration settings are corrupted. Connect your computer
to an electrical outlet to charge the battery. If the problem persists, try to restore the data by entering the
system setup program (see "Using the System Setup Program" on page 149). Then immediately exit the
program. If the message reappears, contact Dell. See "Contacting Dell" on page 155.
T IME - OF - DAY CLOCK STOPPED —
The reserve battery that supports the system configuration settings may
need to be replaced. Contact Dell. See "Contacting Dell" on page 155.
T
IME
-
OF
-
DAY NOT SET
-
PLEASE RUN THE
S
YSTEM
S
ETUP PROGRAM
—
The time or date stored in the system
setup program does not match the system clock. Correct the settings for the Date and Time options. See
"Using the System Setup Program" on page 149.
T IMER CHIP COUNTER 2 FAILED —
A chip on the system board may be malfunctioning. Run the System
Set tests in the Dell Diagnostics. See "Dell Diagnostics" on page 87.
U
NEXPECTED INTERRUPT IN PROTECTED MODE
—
The keyboard controller may be malfunctioning, or a
memory module may be loose. Run the System Memory tests and the Keyboard Controller test in the
Dell Diagnostics. See "Dell Diagnostics" on page 87.
X : \ IS NOT ACCESSIBLE . T HE DEVICE IS NOT READY —
Insert a disk into the drive and try again.
W ARNING : B ATTERY IS CRITICALLY LOW —
The battery is running out of charge. Replace the battery, or
connect the computer to an electrical outlet. Otherwise, activate hibernate mode or shut down the
computer.
IEEE 1394 Device Problems
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide .
E
NSURE THAT THE
I E E E 1 3 9 4
DEVICE IS RECOGNIZED BY
W
INDOWS
—
1
Click the Start button and click Control Panel .
2
Click Printers and Other Hardware .
If your IEEE 1394 device is listed, Windows recognizes the device.
I
F YOU HAVE PROBLEMS WITH A
D
ELL
-
PROVIDED
I E E E 1 3 9 4
DEVICE
—
Contact Dell ( see "Contacting Dell"
on page 155) .
I
F YOU HAVE PROBLEMS WITH AN
I E E E 1 3 9 4
DEVICE NOT PROVIDED BY
D
ELL
—
Contact the IEEE 1394
device manufacturer.
E NSURE THAT THE I E E E 1 3 9 4 DEVICE IS PROPERLY INSERTED INTO THE CONNECTOR
PD598a01.book Page 97 Monday, February 6, 2006 2:24 PM