Dell D610 - Latitude Centrino Laptop 1.6ghz 512mb 40gb Wifi Xp Pro 14" Lcd, Руководство пользователя

Страница: 93 / 115

IEEE 1394 Device Problems
Keyboard Problems
4. Click Remove or Change/Remove and follow the prompts on the screen.
5. See the program documentation for installation instructions.
Sector not found — The operating system cannot locate a sector on the hard drive. You may have a defective sector or corrupted FAT on the
hard drive. Run the Windows error-checking utility to check the file structure on the hard drive. See the Help and Support Center for
instructions. If a large number of sectors are defective, back up the data (if possible), and then reformat the hard drive.
Seek error — The operating system cannot find a specific track on the hard drive.
Shutdown failure — A chip on the system board may be malfunctioning. Run the System Set tests as described in " Using the Dell
Diagnostics ."
Time-of-day clock lost power — System configuration settings are corrupted. If the problem persists, try to restore the data by entering the
system setup program. Then immediately exit the program. See " Using the System Setup Program ." If the message reappears, contact Dell .
Time-of-day clock stopped — The coin-cell battery that supports the system configuration settings may no longer hold a charge. Replace
the coin-cell battery (see " Adding and Replacing Parts "), or connect your computer to an electrical outlet. If the problem persists, contact Dell .
Time-of-day not set-please run the System Setup program — The time or date stored in the system setup program does not match the
system clock. Correct the settings for the Date and Time options. See " Using the System Setup Program ."
Timer chip counter 2 failed — A chip on the system board may be malfunctioning. Run the System Set tests as described in " Using the
System Setup Program ."
Unexpected interrupt in protected mode — The keyboard controller may be malfunctioning, or a memory module may be loose. Run the
System Memory tests and the Keyboard Controller test as described in " Using the Dell Diagnostics ."
x:\ is not accessible. The device is not ready — Insert a disk into the drive and try again.
Warning: Battery is critically low — The battery is running out of charge. Replace the battery, or connect the computer to an electrical
outlet. Otherwise, activate hibernate mode or shut down the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide .
Ensure that the IEEE 1394 device is properly inserted into the connector
Ensure that the IEEE 1394 device is recognized by Windows —
1. Click the Start button and click Control Panel .
2. Click Printers and Other Hardware .
If your IEEE 1394 device is listed, Windows recognizes the device.
If you have problems with a Dell- provided IEEE 1394 device —
If you have problems with an IEEE 1394 device not provided by Dell —
Contact Dell or the IEEE 1394 device manufacturer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide .