Dell 06M4F, Инструкция по установке и обслуживанию

Страница: 113 / 173

Table 60. Riser configurations:1A (continued)
Card type Slot priority Form factor
Infiniband HCA FDR (Mellanox) 1, 2 Low Profile
40G NICs (Intel) 1, 2 Low Profile
40G NICs (Mellanox) 1, 2 Low Profile
FC32 HBA (QLogic) 1, 2 Low Profile
FC32 HBA (Emulex) 1, 2 Low Profile
25G NICs (Broadcom) 1, 2 Low Profile
25G NICs (Mellanox) 1, 2 Low Profile
25G NICs (QLogic) 1, 2 Low Profile
FC16 HBA (QLogic) 1, 2 Low Profile
FC16 HBA (Emulex) 1, 2 Low Profile
10Gb NICs (Broadcom) 1, 2 Low Profile
10Gb NICs (Intel) 1, 2 Low Profile
10Gb NICs (Mellanox) 1, 2 Low Profile
10Gb NICs (QLogic) 1, 2 Low Profile
10Gb NICs (Solarflare) 1, 2 Low Profile
FC8 HBA (Emulex) 1 Low Profile
FC8 HBA (QLogic) 1, 2 Low Profile
1Gb NICs (Broadcom) 1, 2 Low Profile
1Gb NICs (Intel) 1, 2 Low Profile
External RAID (Dell design) 1, 2 Low Profile
Integrated RAID (Dell design) Integrated Slot NONE
rNDC (Broadcom) Integrated Slot NONE
rNDC (Intel) Integrated Slot NONE
rNDC (Mellanox) Integrated Slot NONE
rNDC (QLogic) Integrated Slot NONE
Removing an expansion card riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 71.
2. Follow the procedure listed in Before working inside your system on page 72.
3. Before removing the expansion card riser 2A, remove the expansion card from the riser, if installed.
4. Disconnect any cables connected to the expansion card.
Steps
Hold the touch points, and lift the expansion card riser, from the riser connector, on the system board.
NOTE: While removing the riser 1B, press the tabs and hold the touch point to lift the expansion card riser from the
system board.
Installing and removing system components 113