Next steps
1. Install the expansion card riser 2 or the rear drive cage, depending on the configuration of your system.
2. Follow the procedure listed in
After working inside your system
Integrated storage controller card
Removing the integrated storage controller card
Prerequisites
1. Follow the safety guidelines listed in
on page 71.
2. Follow the procedure listed in
After working inside your system
3.
Steps
1. Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the connector on the system
board.
2. Lift the integrated storage controller cable to disconnect it from the connector on the system board.
Figure 76. Removing the integrated storage controller cable
3. Lift one end of the card and angle it to disengage the card from the card holder on the system board.
4. Lift the card out of the system.
130
Installing and removing system components
