![Dell 06M4F Скачать руководство пользователя страница 150](http://html.mh-extra.com/html/dell/06m4f/06m4f_installation-and-service-manual_85036150.webp)
Figure 103. Installing the VGA module
Next steps
1. Route the VGA cable and connect it to the VGA connector on the system board. For locating the connector, see the
section.
2.
.
3.
4.
5. Follow the procedure listed in
After working inside your system
.
Optional internal USB memory key
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE:
To locate the internal USB port on the system board, see the System board jumpers and connectors section.
For configurations that support USB 3.0 module, the USB 3.0 module cable connects to the internal USB port on the system board. In this
scenario, the default internal USB port is available under the backplane cover. The position of the default internal USB port may vary
depending on the configuration of your system.
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB
memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in
on page 71.
2. Follow the procedure listed in
Before working inside your system
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
on page 169.
150
Installing and removing system components