11
System board
12
NVLink Heat sink and processor
13
Air shroud for NVLink board
14
NVLink board
15
Air shroud
Chassis intrusion switch
The Chassis Intrusion Switch detects any intrusion into the interior of your system and provides an indication of the same in the system
event logs. This switch is activated as soon as the cover of your system chassis is removed.
NOTE:
If the intrusion cable is missing or not connected, a notification is received in the ESM and intrusion status is not logged
in the system event log.
The chassis intrusion switch detects any unauthorized access into the interior of your system and provides an indication of the same. This
switch is activated as soon as the system cover is removed and access is made to the interior of your system.
Removing the intrusion switch
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE:
This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified
service technicians.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Ensure that the GPU power and signal cables do not interfere with the intrusion switch cable.
Steps
1
Disconnect the intrusion switch cable from the connector on the system board.
2
Slide the intrusion switch out of the intrusion switch slot.
58
Installing and removing system components