Figure 73. Installing the socket protective caps
Next steps
1
Remove the NVLink board.
2
Install a SXM2 GPU.
Removing the NVLink Board
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE:
This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified
service technicians.
1
Follow the safety guidelines listed in the Safety instructions section.
2
Follow the procedure listed in the Before working inside your system section.
3
Remove the following components:
a
NVLink air shroud
b
SXM2-GPU Heat Sink
c
SXM2 GPU(s)
CAUTION:
Disconnect the data cable from the system board and then remove the NVLink board to prevent pin damage
in the PCIe connectors.
4
Disconnect and remove the data and power cables from the NVLink board and the system board.
CAUTION:
The expansion card riser cables must be disconnected from the NVLink board before removing the NVLink
board, to prevent pin damage in the PCIe connectors.
Installing and removing system components
117