22
30SD, 36SD, 45SD
Rev. Nov2014
Service Adjustments
Adjusting Drive Cable
If tension seems to be too loose or too tight, the drive
cables needs to be readjusted.
1. Loosen the bolt above where the cable screws in
to the right side of the control panel.
2. Loosening the bolt enables the cable to screw in
further, which makes the augers/impeller handle
tighter.
3. Adjust the bolt and cable
to the necessary
adjustments.
Additional setup procedures
can be found in the transmis-
sion service instructions.
Adjusting Augers/Impeller Cable
If tension seems to be too loose or too tight, the
augers/impeller, cables needs to be readjusted.
1. Loosen the bolt above where the cable screws in
to the left side of the control panel.
2. Loosening the bolt enables the cable to screw in fur-
ther, which makes the
augers/impeller handle
tighter.
3. Adjust the bolt and cable
to the necessary
adjustments.
Additional setup procedures
can be found in the impeller
belt replacement instructions
Adjusting Shift Rod
The shift rod will be at a preset position from the
factory, but after use, or maintenance, the shift rod
may require occasional adjustment.
Signs of adjustment need:
1. The shift handle is moved to the F1 position, and
when the engagement handle is pressed, the unit
does not move.
2. The shift handle is moved to the R1 position, and
when the engagement handle is pressed, the unit
does not move.
If either of the above occur, it may be necessary to
adjust using the following procedure:
1. Set the transmission handle to the space between F1
and R1 as shown on the right.
2. Loosen the 2 nuts on the adjustment turnbuckle.
3. Remove the cover plate from the transmission
housing
4. Adjust the rod by turning the turnbuckle until the
friction wheel aligns with the center of the circular
disk in front of the rubber friction wheel.
