9
30SD, 36SD, 45SD
Rev. Nov2014
Assembly Instructions
Step 1: Control Panel Handles
1. Align the two holes on each side of the control panel
handles over the lower handle frame.
2. Insert the bolts through the handlebar holes and frame
holes. Secure in place with hardware provided. Insert
bolts from the inside.
Step 3:
Chute Rotation Cable
Attach the cable coming from the middle of the
control panel by screwing the cable end onto the
crank section.
See next page for specific instructions regarding
this assembly.
Need Help With Assembly?
1-919-550-3259
Step 2: Directional Discharge Chute
1. Fit the black plastic round spacer onto impeller housing
before installing chute. Apply light coat of grease onto
spacer.
2. Install the bolts for the retainer brackets with the plastic
spacer between the chute and the steel retaining tabs.
DO NOT OVERTIGHTEN. If the bracket is too tight the chute
will not move properly. Ensure there is enough space
between the impeller housing and the bracket on all sides
so that the chute rotates smoothly.
