Deister electronic proxSafe flexx, Инструкции по монтажу и подключению

Страница: 38 / 44

proxSafe flexx
38 ps_flexx_wi_en V08/09/09
5.3 Addressing of flexx housings
After having created the administrator card, the terminal will start the addressing
procedure for the flexx housings. If you operate only one flexx with your terminal, you can
skip this procedure by pressing the red key <C>. The terminal will then continue with
teaching-in the keyTags (see 5.4 „Teach-in of keyTags).
Present one of your keyTags to the built-in
keyTag reader. The doors of all flexx
housings will simultaneously be unlocked
and the following screen is displayed.
After presenting the keyTag to the keyTag
reader, the display prompts you to insert a
keyTag into one of the free proxCylinders.
Insert a keyTag now into one free
proxCylinder of the first flexx housing.
You will hear a beep and the display shows
the following screen:
Now you can remove the keyTag from the
first flexx.
Important:
In most cases there is more than one keyPanel (up to 8) located within one flexx
housing. Make sure, that you do not insert a further keyTag into any proxCylinder of
the same flexx housing! (This will result in address confusion!)
Repeat this procedure for the following flexx housings No. 2, 3, etc. After you have
removed the keyTag from the last flexx, press <C> in order to terminate the flexx
addressing procedure. After the flexx addressing procedure the system may perform
another self-test.
Please present
the keyTag
Press <C> to abort
Insert keyTag into
empty slot
C:Cancel
Please remove keyTag
C:Cancel