Degelman M28, Руководство оператора и каталог запасных частей

Страница: 8 / 45

-6- 142657 - Manure Spreader (17-March-2016)
The Manure Spreader should always be parked on
a level, dry area that is free of debris and foreign
objects. Follow this procedure when attaching:
1. Clear the area of bystanders and remove
foreign objects from the machine and working
area.
2. Make sure there is enough room to back the
tractor up to the hitch pole.
3. Start the tractor and slowly back it up to the
hitch point.
4. Stop the tractor engine, place all controls in
neutral, set park brake and remove ignition key
before dismounting.
5. Use the hitch pole jack to raise or lower the pole
to align with the drawbar.
6. Install a drawbar pin with provisions for a
mechanical retainer such as a Klik pin.
Install the retainer.
7. Install a safety chain between the tractor
drawbar and the hitch pole.
8. Connect PTO driveline to tractor.
9. Connect the Flow Control cable plugs.
Preparation
HOOK-UP / UNHOOKING
10. Connect the Electrical Light plug.
11. Connect the hydraulics. To connect, proceed as
follows:
• Use a clean cloth or paper towel to clean the
couplers on the ends of the hoses. Also clean
the area around the couplers on the tractor.
• Remove the plastic plugs from the couplers and
insert the male ends.
NOTE: If the direction of motion is wrong,
reverse the couplers.
12. Raise the hitch jack and rotate it 90º to place in
its stowed position or relocate on jack bushing
located on the side frame (see detail below).
13. When unhooking from the tractor, reverse the
above procedure.
NOTE: Occasionally air may become trapped
in the hydraulic circuit, making it necessary to
“bleed” the circuit.
To perform this operation cycle the hydraulics
several times or especially on older tractors,
temporarily loosen an easily accessible hose
fitting enough to allow any trapped air to escape
while cycling the hydraulics. Retighten fitting.
PTO: Connect the PTO Driveline
• Check that the PTO driveline
telescopes easily and the shield
rotates freely
• Attach the driveline to tractor by:
- Retracting the locking collar
- Slide the yoke over the shaft
- Push yoke until lock collar clicks
into position
Connect the Hyd. lines
• Clean off couplers on
hose & tractor with cloth
• Remove plugs & insert
couplers
- Ensure pressure & return
lines are matched up on
same valve bank
Turn jack sideways for field position or relocate on side.
Install a safety chain
between tractor drawbar
and the hitch pole.
• Always park on a level surface
clear of debris and obstacles.
Connect Flow Control
• Connect the cable
plug ends from the
flow control
box to the valve
assembly.
Connect Electrical
Lights Plug