Operation
18
Operating Instructions - Dedy Chocolate Enrobing Machine 220 mm and 320 mm
Getting started
•
Always check that the mesh conveyor is moving freely before starting up the
enrobing machine!
•
Proceed as follows:
Undo the two knurled screws
(Fig. 8)
, pull the mesh conveyor out slightly
(Fig. 9)
and check that the mesh conveyor coupling is free.
Insert the VDE key provided
(Fig. 10)
into the casing and turn it. If the key
can be turned easily, the mesh conveyor is moving freely. Take the key out
again, push the mesh conveyor in and tighten the two knurled screws.
Fig. 8: Undo knurled screws on mesh conveyor
Fig. 9: Pull out mesh conveyor and check coupling
Fig. 10: Insert special key and check mesh conveyor is moving freely
•
Connect the machine to the 230 V mains supply.
•
Set the main switch to “ON”
(Fig. 7; No. 12)
.
•
Press the RESET button
(13)
until the red lamp goes out.
