Dedicated Micros HyperSense, Руководство по установке

Страница: 13 / 28

Dedicated Micros ©2008
1
ANPR
Configuring the Unit
- Intelligent CamVu version only
Locating the unit IP address
The unit is configured using the on-board web pages. This can be done remotely once the unit has
been installed in position.
The IP address of the unit is required to access these pages. The assigned IP address can be found
by using the serial port. For ease of configuration, it is recommended that the installer sets the IP
address before installing the unit in position.
DHCP should be disabled and a permanent IP address should be assigned to the unit. If this is
not done, the IP address of the unit may change whenever it is powered off, and the new address
will have to be acquired directly from the unit (ie using a serial connection or by connecting a spot
monitor and cycling the power).
It is recommended that DHCP is initially enabled to allow the unit to acquire a free IP address and
then allocate the address permanently by entering the details in the IP address fields of the cameras
Network web page, which will also disable DHCP.
If a permanent IP address is not assigned to the unit, it will attempt to contact the DHCP server
every time it starts up. If for any reason a DHCP server cannot allocate an IP address to the unit, the
camera will use a default IP address (169.254.6.10).
Note: Always consult the network administrator for IP Address, Subnet Mask and Gateway
information.
To acquire the IP address using the serial connection;
1. On the PC, click Start->Programs->Accessories->Communications->Hyperterminal and create a
new connection via the COM port using the following settings:
Bits per second 38400
Data Bits 8
Parity None
Stop bits 1
Flow Control None
2. With the power to the camera disconnected, connect a standard 9DF-9DF RS232 communications
cable from the PC to the serial port of the unit, refer to Appendix B Serial pinouts . Connect power
to the camera.
3. Hyperterminal will display the communications information as the unit boots. This will include the IP
address, Subnet and Gateway.
4. To alter the IP address settings of the camera from the Hyperterminal, input the following
information after the camera has finished its startup:
setip followed by the new IP address e.g. setip 192.168.1.100
setsub followed by the new subnet mask e.g. setsub 255.255.0.0
setgw followed by the new gateway address e.g. setgw 192.168.50.1
reset (to reset the camera so that the new IP address settings are adopted)