Dedicated Micros HyperSense, Руководство по установке

Страница: 12 / 28

Dedicated Micros ©2008
1
ANPR
4. The FOV and Focus can now be adjusted, refer to Methods of adjusting focus and FOV . Once
Focus and FOV are correct, tighten the screws on the levers to prevent them being effected by
vibration.
5. Replacing the body is the reverse procedure.
Note: Ensure all screws are tightened during reassembly to maintain a watertight seal.
Note: To remove the body and sunshield from the platform completely, unscrew the 2 x M3 nuts
from the suspension bracket whilst the body is in the hanging position.
Methods of adjusting focus and FOV
The analogue version of the camera can have a local monitor connected to the BNC. The IP version
of the camera will require the camera connecting to the network, and a PC or laptop connected to
the same network running NetVu ObserVer to enable fine focus.
Models that incorporate the overview camera can be adjusted by setting the overview image and
then setting the zoom and focus levers on the ANPR camera lens to the same positions as the
Overview camera to get an approximate FOV and focus set on the ANPR camera.
Models without the overview camera
• This camera will only show the number plate of the vehicle on the image. DM recommends that the
area to be viewed be closed off and a vehicle parked within the target area during configuration, to
allow the best possible adjustment.
• Alternatively, a vehicle number plate can be held within the area to allow camera adjustment.
Note: Safety is paramount. Do not stand in the road unless the road has been closed.
• If the road cannot be closed or the road is busy, passing traffic can be used to configure the
camera.