Dean Forge Dartmoor 5E, Руководство по эксплуатации

Страница: 8 / 18

Page 8 of 18
Corner installation from
Rear and side wall installation
combustible walls from combustible walls
Spigot Shield
The minimum distances to combustible materials have been tested and approved when a spigot shield
is fitted to the top of the heat shield. The spigot shield must be fitted to achieve these distances. The
spigot shield “which is in the glove pack” fits to the top of each heat shield projecting up using the two
screws which are located in their holes at the top of the stove heat shield. See diagram below
Baffles
Once all the packaging has been removed and the stove is in its final position you must make sure all
the fire bricks and baffles plates are in place. Particular attention must be taken when checking the top
baffle plate is in place. See diagram below.
.
The Top vermiculite baffle sits on a ledge across the front and on an angle bracket to each side
towards the rear. If the top baffle has a section cut out this must be positioned with the cut out at the
rear.
The lower baffle on the W5 is steel with a vermiculite brick that sits inside to the top face. The steel
section is held up by the two outer bricks to each side and the steel ledge to the rear of the stove. The
folds in the steel baffle must point up and the vermiculite brick sits between the folds.
The Dartmoor 5 lower baffle is vermiculite only which is also held up by the two outer bricks to each
side and the steel ledge to the rear of the stove.