Dean Forge Dartmoor 5E, Руководство по эксплуатации

Страница: 11 / 18

Page 11 of 18
Installing a Multi-fuel kit in a Dartmoor 5 Eco
.
To install a multi-fuel kit into a Dartmoor 5 woodburner first remove the inner side bricks by lifting the
baffle plate up on one side above the side brick then slide the side brick out being careful not to
damage it. This needs to be repeated on the other side but this time you must hold the baffle plate to
stop it falling out. Once both side bricks are removed the baffle plate can then be removed as well as
the log retainer. Remove a cover bolt, where the riddle bar will be fitted, which is on the left side on
the outside face of the stove the nut is on the inside.
Dartmoor 5 Eco with Multi-fuel kit installed
Now you are ready to install the multi-fuel kit.
1. Fit the main grate frame (C) with the legs at the back of the stove, slide the frame forward making
sure the front of the frame sits on the brackets which are each side near the front of the stove.
2. Unscrew the stainless-steel knob (J) off the riddle bar and hook the bar through the hole in the
arm of the centre grate (D) making sure the riddle bar sits under the centre grate arm.
3. Fit the centre grate (D) with the arm pointing to the left and feed the riddle bar through the hole
in the front of the stove.
4. Re-fit the baffle plate (B) using the new shorter side bricks.
5. Fit the rear infill plate (E). The support bar welded to one side points down and sits against the
back of the main grate frame the other side leans against the rear brick.
6. Fit the new fuel retainer making sure the bars sloping down, away from you towards the grate.
7. Fit the ash pan (I) under the fire grate.
8. Fit the door rope seal. Remove the two bottom door glass retainers (be careful the glass does not
fall out). Slide the two glass retainers into the two cut-outs between the channel and the rope
seal. Ease the rope slightly back to locate the glass retaining screws through the retainers and the
holes in the channel. Screw the channel/rope seal to the door with the glass retainers pointing up
to hold the glass in place. Gently push the rope seal back over the screw in the channel