M A N A G E M E N T C O N S O L E
Data Device Corporation
FC-76000 Manual
www.ddc-web.com
Rev A-01/10-0
30
PTE XXXX
Port Enable Bit Mask field: each bit corresponds to a physical port, with the LSB
being port #0, etc. Frames mapped to this route will be sent out each port whose bit
is set in this mask. The Type field must be set to 2 (multicast) if multiple bits are set
in this field or the WKA =1. There is a space between the command and value.
Range: 0x0000 – 0xFFFF
Format: Hexadecimal
This field is the equivalent of the
MASK
entry in the interactive routing table
configuration menu (section 4.2.5.8).
PTM XXXX
Port Mask Select field: each bit corresponds to a port. This routing entry will be
written to each port whose bit is set in this mask. Writing the routing entry to
SPECIFIC port is useful for debugging, but for normal operation set this field to
0xFFFF (see last sentence). Simultaneously, this route will be written into the master
Routing Table. If the routing table is subsequently written to Flash, this route will be
loaded into ALL ports after reset or power cycling has occurred.
Range: 0x0000 – 0xFFFF
Format: Hexadecimal
This field has no equivalent in the interactive routing table configuration menu
(section 4.2.5.8) and is automatically set to all ones when the routing table entry is
written.
END\R\N
Command terminator. The end of line sequence is \r\n, ASCII codes 13 10.
4.2.5.9.3 Global Configuration Download Command
Note:
The function of the GC command has NOT been verified in this release.
This command is used to configure global switch settings. Please see section 4.2.5.4
for an explanation of the global configuration options. An example of the Global
Configuration command is shown below:
#GC S07 1 S8F 2 AM0 1 LUM 0 EDT 1F4 END
The fields that make up this command are defined as follows:
#GC
Global Command field: Identifies the Global Configuration command
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
