Davey DynaDrive DD160-19, Инструкция по установке и эксплуатации

Страница: 3 / 32

3
ATTENTION: The DynaDrive system and associated pipework operate under pressure.
Under no circumstances should the DynaDrive system, or associated pipework be
disassembled unless the internal pressure of the system has been relieved. Failure to
observe this warning will expose persons to the possibility of personal injury and may
also result in damage to the pump, pipework or other property.
Prior to installation remove the inlet and outlet pipe transport plugs & associated seals from the suction
and/or discharge ports.
1. PRIOR TO USING THIS PRESSURE SYSTEM, YOU MUST ENSURE THAT
• The pump is installed in a safe and dry environment
• The pump enclosure has adequate drainage in the event of leakage
• Any transport plugs are removed
• The pipework is correctly sealed and supported
• The pump is primed correctly
• The power supply is correctly connected
• All steps have been taken for safe operation
Appropriate details for all these items are contained in the following Installation and Operating Instructions.
Read these in their entirety before switching on this pump. If you are uncertain as to any of these Installation
and Operating Instructions, please contact your Davey dealer, or the appropriate Davey office as listed on
the back of this document.
2. YOUR NEW SYSTEM
1. Suction inlet
2. Pump body
3. Pump priming plug
4. Discharge/delivery outlet
5. DynaDrive control module
6. Motor
7. Pressure tank
DD60-10, DD90-11 DD90-13, DD160-19
Figure 2.1 Figure 2.2