Datavideo iCast 10NDI, Инструкция по эксплуатации

Страница: 38 / 96

38
6. You will be allowed to manually enter the static IP address after the DHCP mode is disabled. Please
note that the static IP is 192.168.1.201 by default.
-
Static IP: X.X.X.Y; the first three decimal numbers must be the same as your router or switch.
The number Y must be a number not used by any devices connected to the network.
-
Subnet Mask: 255.255.255.0
-
Default Gateway: Z.Z.Z.Z; same as the gateway IP of your router or switch.
Note: Some router may require special gateway IP setting
instead of the standard
192.168.1.1. Therefore, you should check the network properties on the PC before
switching to the fixed IP mode. For example, some routers have a gateway IP of
192.168.1.254 and as a result, the default gateway and primary DNS fields
must also be
configured to 192.168.1.254.
-
Primary DNS: Same as the default gateway IP, which, if causing issues, can be changed to
8.8.8.8 or 8.8.8.4 (Public DNS provided by Google).
7. After you’ve set the static IP, you can either establish point-to-point connection with iCast 10NDI
on your computer or connect iCast 10NDI to a network with the same IP range.
Tip: If you forget or lose the IP address, you can either reset the device by inserting a needle into
the reset hole at the rear panel then push and hold for several seconds until the system starts
resetting itself, or you can do the following to reset the network settings.

Turn off iCast 10NDI.

Push the RECORD and STREAM buttons at the same time then turn ON the device power.

Wait for about five seconds then release the buttons as soon as you see the RECORD and STREAM
button LEDs light up.

The IP address should be the default IP which is 192.168.1.201.
Troubleshooting the Network Connection
Connect the iCast 10NDI to the network then use the IP Finder utility program to scan for the device.
If not found, it is possible that your network is not assigning IP addresses. Reasons of this are
outlined as follows:

The Router or the DHCP server is not connected to the network.

New devices are blocked by the network administrator.

Anti-virus software or the firewall blocks the communication.
1. Solve the problem by trying the following:

Turn off the router, wait for 10 seconds then turn on the router again.

Reset the iCast 10NDI’s network setting to the factory default:
-
Turn off iCast 10NDI.
-
Push the Record and Stream buttons simultaneously while turning on the iCast 10NDI’s
power.
-
Wait for about five seconds and release the buttons as soon as you see the RECORD
and STREAM button LEDs light up.

Reboot the PC.
2. If the problem still persists, try the following ways: