Datalogic PowerScan PBT9500, Руководство по программному обеспечению

Страница: 23 / 60

Subnet Mask Enter/Exit Programming Mode
Ethernet Software Reference Guide 19
Subnet Mask
The subnet mask number is combined with the IP address number to
identify which network segment the BC9180™ is on.
A subnet mask is a 32-bit number that is composed by using four num-
bers from 0 through 255, separated by periods. Typically, default subnet
mask numbers use either 0 or 255 as values (such as 255.255.255.0),
but other number values can appear.
To connect the Cradle to an existing LAN, specify the Subnet Mask that
the LAN uses
.
$CETSM
Set Subnet mask
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by 8
digits (in hex) from the Alphanumeric characters in
Appendix B, Keypad
representing your desired
character(s).
Exit programming mode by scanning the ENTER/
EXIT barcode again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL
DEFAULT
Default Subnet mask = FFFFFF00,
hexadecimal representation of 255.255.255.0