Datalogic DS41-X0, Руководство по установке

Страница: 14 / 53

DATALOGIC DS41
General features - 1.3
Electrical connection is provided through a cable on the side of the reader;
this cable is terminated with a 25-pin connector (25-pin connector models,
see paragraph 1.3, Figure A,
1
) or by a junction box (junction box models,
see paragraph 1.3, Figure B,
1
).
The laser beam output window is on the right hand side of the scanner
(Figure A,
10
). A green LED on the same side indicates the laser is active
(Figure A,
9
).
A security system allows the laser to activate only once the motor has
reached the correct rotational speed; consequently the laser beam is
generated after a slight delay from the power on of the scanner.
The four LEDs on the left hand side of the scanner indicate the following:
POWER ON
LED (red) (Figure A,
3
) indicates the reader is connected to
the power supply.
GOOD READ
LED (red) (Figure A,
4
) is used to signal successful barcode
decoding. It is also used in Test mode to signal the decoding
percentage (for details refer to the section "Test Mode" in the
WINHOST Help On Line).
EXT TRIG
LED (yellow) (Figure A,
5
) indicates the code presence
sensor is active (for details refer to the section "On Line
Mode" in the WINHOST Help On Line).
TX DATA
LED (green) (Figure A,
6
) indicates data transmission on
the main serial output line.
The screw holes on the body of the reader are for mechanical fixture (Figure
A,
2
); the screw holes shown in Figure A,
11
are to attach accessories such
as the optional 90° mirror.