i50 Manual (5.51)
Page 33
© 2018 Datalink Systems, Inc.
www.datalinksystemsinc.com
Radio
Radio COM Speed:
RF modem COM speed.
Radio Serial Config:
Serial settings for RF port.
Ack Time:
Time to wait after receiving data before replying over an RF
modem. This provides time for half-duplex modems to switch
from transmit to receive mode.
Kenwood:
Kenwood radio settings. Enabling the Software ACKs option will
ensure data is received by the server, but will increase radio
traffic. With this disabled, the i50 will rely on radio ACKs only.
When WAN mode is enabled, the i50 will automatically switch
the radio channel/zone when sending data, based on waypoint
locations. Selecting the Transparent option causes the i50 to
send raw data packets, which requires the Kenwood radios to
be configured for transparent data. The Revert to Voice
Channel option causes the i50 to switch back to the current
channel when finished sending data. When Auto-Roam (and
WAN Mode) is enabled, the i50 will select the current radio
channel/zone, based on waypoint locations.
Kenwood Base TX Fleet/Type: Kenwood base radio fleet ID (Fleetsync) or ID type (NXDN).
Together with the Kenwood TX Base ID setting, this is used as
the destination when sending data over a Kenwood radio.
Kenwood Base TX ID:
See above.
Kenwood Base RX Fleet:
Kenwood base radio fleet ID (Fleetsync only). Not used for
NXDN networks. See below.
Kenwood Base RX ID:
Kenwood base radio ID (combined with Kenwood RX Fleet ID
for Fleetsync). The i50 will only accept data from this radio ID.
Kenwood Idle Timer:
i50 will not transmit over the radio until it has been idle (no call
activity) for at least this interval.
Globalstar
Globalstar COM Speed:
Globalstar modem COM speed.
Globalstar Server IP:
DataGate server address when sending data over Globalstar.
Also used to allow data through the firewall.
Backup Globalstar Server IP:
Backup address, used when remotely switching servers.
Globalstar Timeout:
This timer limits how long a Globalstar connection will stay
active if no data is sent or received.
Globalstar RX Port:
UDP RX port for Globalstar.
Globalstar TX Port:
UDP TX port for Globalstar.
