Datakom D-500 MK3, Руководство пользователя

Страница: 142 / 197

D-500 MK3 User Manual Firmware V-7.5
- 142 -
Related parameters are:
Parameter Definition Factory Set Description
SMS Enable 0
0: SMS messages disabled
1: SMS messages enabled
GPRS Connection
Enable
0
0: GPRS disabled
1: GPRS enabled
SMS on Mains
Change
0
This parameter controls SMS sending when mains
voltages status is changed. No warnings generated.
0 : no SMS on mains failed or restored
1 : SMS sent on mains failed or restored
SMS on Engine
Run/Stop
0
This parameter controls SMS sending when the engine
runs or stops. No warnings generated.
0: no SMS on engine run/stop
1: SMS sent on engine run/stop
SMS Commands
Enabled
0
0: SMS commands not accepted
1: SMS commands are accepted but from listed
telephone numbers only.
GSM Location Active 0
0: no location information from GSM
1: location information read from GSM system.
APN User Name
The APN (access point name) username may be required by the GSM
operator. However some GSM operators may allow access without username.
The exact information should be obtained from the GSM operator.
Please search the GSM operator’s website with “APN” string.
APN Password
If the APN (access point name) username is required by the GSM operator,
most probably the APN password will also be required. However some GSM
operators may allow access without password.
The exact information should be obtained from the GSM operator.
Please search the GSM operator’s website with “APN” string.
APN Name
The APN (access point name) is always required by the GSM operator.
The exact information should be obtained from the GSM operator.
Please search the GSM operator’s website with “APN” string.
20. GSM CONFIGURATION
Signal Strenght
Indicator
Modem is Ready
GPRS Status
Indicator
IP address
Data Receive
and Transmit
Indicators
RainbowScada
packet counter