Datacolor 9020-0129, Руководство по эксплуатации

Страница: 120 / 127

Datacolor CONDITIONER™ (MB2) 06/2017 page 120/126
Only qualified service personnel authorized by Datacolor representative must perform repair.
Repaired cabinets must comply with the manufacturer’s quality standards.
23. Technical description
23.1 Factory calibration and adjustment
This cabinet was calibrated and adjusted in the factory. Calibration and adjustment were performed using
standardized test instructions, according to the QM DIN EN ISO 9001 system applied by the manufactur-
er (certified since December 1996 by TÜV CERT). All test equipment used is subject to the administration
of measurement and test equipment that is also a constituent part of the manufacturer’s QM DIN EN ISO
9001 systems. They are controlled and calibrated to a DKD-Standard at regular intervals.
Repeated calibrations are recommended in periods of 12 months.
23.2 Over current protection
The devices are equipped with an internal fuse not accessible from outside. If this fuse is blown, please
contact an electronic engineer or your local Datacolor service representative.
23.3 Definition of usable volume
The usable volume illustrated below is calculated as follows:
c
c
b
a
C
B
A
b
a
A, B, C = internal dimensions (W, H, D)
a, b, c = distance to wall
a = 0.1*A
b = 0.1*B
c = 0.1*C
V
USE
= (A - 2 * a) * (B - 2 * b) * (C - 2 * c)
Figure 23: Determination of the useable volume
The technical data refers to the defined usable volume.
Do NOT place samples outside this usable volume.
Do NOT load this volume by more than half to enable sufficient airflow inside the cabinet.
Do NOT divide the usable volume into separate parts with large area samples.
Do NOT place samples too close to each other in order to permit circulation between them
and thus obtain a homogenous distribution of temperature and humidity.