DataCard SD Series, Руководство пользователя

Страница: 63 / 106

SD Series Card Printers User’s Guide 51
There are scratches or
particles under the
patch.
The inside of the printer
is dirty.
Clean the printer. Refer to “Run a Printer
Cleaning Card” on page 30 .
The supplies have
debris on them.
Store and handle supplies carefully. Keep
supplies in the original packaging until
you are ready to use them.
There are repeating
marks on the patch.
The heated roller is
dirty.
Clean the laminator. Refer to "Clean the
Laminator" on page A-12 . If the problem
continues to occur, contact your service
provider.
The patch doesn’t
adhere to the trailing
edge of the card.
The overlay is wound
incorrectly on the take-
up spool.
Process another card to allow the overlay
material to reset itself. If it doesn’t,
remove the cartridge and turn the take-
up spool clockwise several turns.
The patch is not
centered between the
long edges of the card.
The overlay is not
loaded correctly in the
cartridge.
Load the overlay material correctly. Refer
to "Load Laminator Overlay Material"
on page A-8 .
The laminator cartridge
is not fully seated in the
laminator.
Make sure that the cartridge is seated in
the laminator properly.
The overlay material is
wound unevenly on
the supply roll.
Process several cards to allow the overlay
material to center itself.
Align the edges of the overlay on the
take-up spool.
The laminator cartridge
is damaged.
Replace the laminator cartridge.
The patch has wavy
lines along the length
of the card.
The temperature for
applying the overlay is
set too high.
Decrease the laminator temperature
setting. Refer to the Printer Manager
“Laminate Type” section of the printer’s
Installation and Administrator’s Guide .
The heated roller is
damaged.
Power down the system. Contact your
service provider for assistance.
The card has features,
such as a smart card
chip, that interfere with
application of the
overlay.
Use the correct patch material for your
card type. Refer to "Laminator Overlay
Materials" on page A-6 for a description
of overlay types.
Problem Probable Cause Solution