DataCard SD Series, Руководство пользователя

Страница: 66 / 106

54 Troubleshooting
The topcoat shows
opaque areas along a
short edge of the card.
The temperature for
applying the topcoat is
too high.
Decrease the laminator temperature for
the overlay material. Refer to the Printer
Manager “Laminate Type” section of the
printer’s Installation and Administrator’s
Guide .
If the problem continues to occur,
contact your service provider for
assistance.
The hologram of the
topcoat doesn’t
appear on the card.
The Card Printer Driver
Laminate card setting
is set to Do not apply.
Change the Laminate card setting to
apply the overlay. Refer to the printer’s
Driver Guide for information about
specifying lamination settings.
Clear topcoat is
installed in the
cartridge.
Remove the cartridge and change the
overlay to the correct type.
The overlay material is
wound in the wrong
direction on the take-
up spool.
Process another card to allow the overlay
material to reset itself. If it doesn’t, remove
the cartridge and turn the take-up spool
clockwise several turns.
The overlay is not
loaded correctly in the
cartridge.
Remove the cartridge and reload the
overlay. Refer to "Load Laminator
Overlay Material" on page A-8 .
A long edge of the
topcoat doesn’t stick
to the card.
The temperature of the
heated roller is too low
Increase the laminator temperature for
the overlay. Refer to the Printer Manager
“Laminate Type” section of the printer’s
Installation and Administrator’s Guide .
Print ribbon that
includes a topcoat (T)
panel is loaded in the
printer.
Change the print ribbon to one that
doesn’t include a T panel.
The cards do not meet
specifications.
Use a different supply of cards.
The overlay material
was wound in the
wrong direction on the
take-up spool.
Process another card to allow the overlay
material to reset itself. If it doesn’t, remove
the cartridge and turn the take-up spool
clockwise several turns.
There is debris on the
heated roller.
Process several cards to see if the
problem corrects itself. If it doesn’t, clean
the laminator. Refer to "Clean the
Laminator" on page A-12 .
Problem Probable Cause Solution