DataCard CR805, Инструкция по установке и руководство администратора

Страница: 110 / 152

94 Printer Manager

ExceptionCardImpressPositionOffset2—Set the distance from the trailing edge of the card to
the center of the second impression on the card.

Increase the offset value to increase the distance of the impression from the trailing edge
of the card.

Decrease the offset value to decrease the distance of the impression from the trailing
edge of the card.

ExceptionCardImpressPositionOffset3—Set the distance from the trailing edge of the card to
the center of the third impression on the card.

Increase the offset value to increase the distance of the impression from the trailing edge
of the card.

Decrease the offset value to decrease the distance of the impression from the trailing
edge of the card.

ExceptionCardImpressTemperature—Set the temperature of the impresser punch (in
degrees Celsius).

Increase the value to increase the temperature of the impresser punch.

Decrease the value to decrease the temperature of the impresser punch.

ExceptionCardNumberOfImpresses—Enter the number of impressions to be stamped on the
card. The impresser can stamp up to three impressions in a row on the left, center, or right
part of the card.

HeaterMinutesToPowerSave—Set the number of minutes before the laminator and
impresser heaters are turned off. After the specified number of minutes, the heaters are
allowed to cool down. Using power save requires a warm-up period before the laminator is
ready to laminate cards again. The front panel LCD displays the message Busy Warming up
and a percentage that indicates the status of the heaters.
Hopper 1 Settings
Use the following settings to specify values for cards picked from the input hopper. Set up the
input hopper for the most commonly used card type.
Hopper 1 Debow Settings:

Hopper1CardDebowDirection—Set the direction of the debow action in the laminator to
return the card to its proper shape after an overlay is applied. A card may become bowed
slightly due to heat from the laminator.

Down—The debow arms in the laminator press down on the card.

Up—The debow arms press up on the card.