DataCard CR805, Руководство пользователя

Страница: 114 / 136

98 Troubleshooting
277: Multi-hopper pick error
The multi-hopper did not pick a card from the input hopper cartridge.
1.
Unlock the multi-hopper.
2.
Remove each cartridge and make sure that cards are loaded properly.
3.
Make sure that the cartridges are installed correctly.
4.
Check the exception slide.
5.
Lock the multi-hopper.
Laminator Messages
The following messages display on the printer LCD panel when you are using a laminating system.
They also display in a message on the PC that issued the card print job when you use the Card
Printer Driver.
177: Laminator not available
The printer and laminator cannot communicate. The card will be canceled.
1.
Make sure the data cable from the laminator to the printer is securely plugged in.
2.
Press the printer P
OWER
button to power off the system.
3.
Press the P
OWER
button again to power on the system.
On the PC, click Retry, or click Cancel to cancel the card.
196: Laminator error critical
The laminator has encountered a critical error. The card will be canceled.
1.
Press the printer P
OWER
button to power off the system.
2.
Request service. The system must remain powered off.
On the PC, click OK to clear the message.
197: Laminator entry card problem
The card is not where it should be in the laminator.
1.
Open the laminator.
2.
Turn the knob to remove the card.
3.
Close the laminator.
On the PC, click Retry, or click Cancel to cancel the card.