DAS Energy 6x1M RJB, Руководство по установке, Страница: 9 / 24

Disclaimer: A claim under warranty solely exists when the from DAS Energy and Innotec prescribed adhesives
are used and processed in accordance with the bonding instructions by Innotec. In addition, please note that the
mounting via bonding inevitably leads to irreversible or difficulty repairable modifications of the substrate the
modules are bonded on. DAS Energy is not liable for possible damages to the substrate due to the assembly or
rather disassembly of the modules.
Bonding on plastic
roof sheetings
Bonding on bitumen
roofing membranes
Bonding on metal
sub-constructions
IV. MODULE INSTALLATION
During installation, the installer must unconditionally follow the general rules for safety at
work, the rules for electrical installation and devices, the local applicable construction rules
and all other regional and national rules and regulations.
DAS Energy modules are typically mounted via bonding, either directly on a substrate or, if necessary, on a
supporting sub-construction. The bonding method depends on the material and the properties of the substrate.
Alternatively, the modules can also be bolted, e.g. to a metal sub-construction, by means of holes or eyelets in
the module edge zones.
The PV modules can be mounted in landscape or por-
trait orientation. In any case, the adhesive beads must
be applied in water flow direction. Identify and, if possi-
ble, leave out recurring sources of dirt and avoid shad-
ing sources. Install the cable tray at a distance of at least
10 mm from the roof and, where possible, in water flow
direction, so that rainwater can drain unhindered (refer
to V. Electrical installation: Cable trays).
The DAS Energy PV modules are intended to be bonded
directly onto a roofing membrane or roof sheeting, or,
alternatively, onto a supporting sub-construction. For
this purpose, please follow the bonding instructions by
Innotec (refer to Bonding instructions, Art. no. 199131-2).
Use only the from DAS Energy and Innotec prescribed
adhesives “
Versabond Photovoltaic ” or “ Adheseal Pho-
tovoltaic ” as well as the cleaning agent “ Multisol Pro ject ”
with the cleaning cloth “ Multi Wipes ”, all from Innotec.
Note the processing temperature of the adhesive and
the temperature of the substrate. Make sure the sub-
strate as well as the backside of the PV module is dry
and free of dust and grease before gluing (e.g. rust, old
paint, etc. must be removed upfront). With the follow-
ing QR codes training videos for the appropriate instal-
lation of the DAS Energy PV modules via bonding can
be found.
MOUNTING VIA BONDING
In any case, do not modify the module backside!
Plug & socket must not get into contact with the cleaning agent Multisol Project!
7 Module installation