DAS Energy 6x1M RJB, Руководство по установке, Страница: 12 / 24

The DAS Energy PV modules are equipped with QC4
connectors from the type
“MC4-Evo2” from TE Con-
nectivity (TE). The connectors are designed for an
easy and fast connection without any special tool.
Despite the connectors are sunlight resistant and
waterproof (protection class IP 68), avoid direct sun-
light exposure and water immersion, where possible.
MC4-Evo2 is exclusively compatible with the entire MC4 family.
CONNECTORS
COMPATIBILITY
Always keep the connectors dry and clean. Any kind of pollution (dust, humidity, foreign particles etc.) during the
assembly process can degrade contact and connectors performance. A clean assembly environment is therefore
essential. Unconnected connectors must always be protected from pollution (e.g. dust, humidity, foreign parti-
cles, etc.), prior to installation. Do not leave unconnected (unprotect ed) connectors exposed to the environment.
Therefore, remove the protective dust caps from the connectors only just before the electrical connection. Plugs
and junction boxes must not get into contact with the Multisol Project cleaning agent!
Do not attempt to make an electrical connection with wet, soiled, or otherwise faulty connectors. Faulty connec-
tions can result in arcs and electrical shock. Check that all electrical connections are se curely fastened and make
sure that all locking connectors are fully engaged and locked.
DAS Energy disclaims all liability and does not cover damages (and consequential damages) in the event of:
Assembly, installation or use of the product not in accordance with DAS Energy’s instructions and specification
(documentation, operating or assembly instructions, special recommendations, etc.) or industry standards; [...].
In certain cases, it might be necessary to replace the
pre-assembled MC4-Evo2 connectors of the DAS Ener-
gy PV modules by connectors from another type and/
or manufacturer in order to maintain the compatibility require ments according to IEC 62548 and this manual.
The replacement of the pre-assembled QC connectors
is permitted without the loss of warranty only under
the following conditions:
CONNECTOR REPLACEMENT
10 Electrical installation