DAS Energy 6x1M RJB, Руководство по установке, Страница: 5 / 24

HANDLING OF THE MODULES
• Do NOT attempt to transport, handle, or install the
modules by yourself without a second person. Trans-
port, handling, and installation of the modules should
be done by at least two persons.
Do NOT bend or snap the modules (remark: the mod-
ules are flexible but should only be bent when finally
mounted on a round mounting base).
Do NOT place the modules on the corners nor on the
edges!
Do NOT apply forces while laying the modules down
(do not throw the module).
Do NOT apply focused pressure on the modules in or-
der to avoid punctures, cuts, or tears.
Do NOT step on the modules (depending on the under-
ground the modules can eventually be damaged).
Do NOT lean the modules on sharp or spiky objects.
Do NOT drop heavy or sharp objects onto the modules.
Do NOT use the junction box or the connection cable as
a help for handling.
Do NOT cut or pierce the module as this may cause live
components to be exposed and/or damage the module.
Do NOT bend or apply excessive force to the cables.
Do NOT stack modules (the junction box shall not be in
contact with the front surface, because the sharp edg-
es of the junction box may damage the front surface).
Do NOT scratch or hit the module frontside or the
backsheet.
Do NOT apply paint, varnish, or protective coatings to
the modules.
Do NOT dismantle or remove any part or label at-
tached by the manufacturer.
Do NOT open the original packaging during transpor-
tation and storing until installation. At the same time,
please protect the packaging from damage and store
the packages securely in a ventilated, cool, and dry
room until installation. The packaging is not weath-
er-proof.
Do NOT attempt to repair a damaged module.
Do NOT concentrate sunlight (e.g. mirrors or lenses) or
other sources of artificial light on the modules.
Do NOT use photovoltaic modules in the presence of
inflammable or explosive substances.
Maximum bending: DAS Energy modules are flexible, but
they cannot be rolled-up or folded. Poly- and monocrys-
talline modules may be bent up to a maximum radius of
2,000 mm (only the long side of the module should be
bent). Smaller radii are not permitted. Excessive bending
must be avoided when handling the mod ules. The maxi-
mum bending mentioned should be understood only for
one-time bending to permanently mount the modules on
round surfaces. The modules are not designed to with-
stand such maximum bending radius for applications
where bending occurs repeatedly or periodically. The
bending process must be done uniformly as punctual
bending may cause permanent damage to the cells. The
modules should not be held only on the short ends or
corners as this may cause excessive bending under their
own weight.
Not following those points may cause single PV cells to
break inside the module or injure the protective layer of
the composite! Mishandling of the module may lead to a
decrease of the performance or aspect of the mod ules,
for which DAS Energy shall not be held liable.
II. SAFETY INSTRUCTIONS
The correct handling of DAS Energy modules is essential for the durability of the product. Therefore, the most im-
portant notes on proper handling of the modules are listed below.
Make sure to read through and observe the following safety instructions, in order to avoid personal
injuries and damages on the modules under all circumstances.
3 Safety instructions