DAS Energy 6x1M RJB, Руководство по установке, Страница: 4 / 24

DAS Energy cannot control the use of this safety, in-
stallation, and instruction manual or the conditions
and procedures for installing, operating, using, and
maintaining the modules. Therefore, DAS Energy as-
sumes no responsibility and expressly disclaims lia-
bility for loss, damage, injuries, casualties, or expense
arising out of or in any connection with installation, op-
eration, use or maintenance of the modules. Any mod-
ifications or any use of DAS Energy products contrary
to their specifications and not expressly authorized by
DAS Energy will result in a loss of any liability claims. The information in the manual is based on the knowl-
edge and experience of DAS Energy and is considered
to be accurate and reliable. However, information,
product specifications and sugges tions have neither
the explicit nor implicit nature of a guarantee. DAS
Energy reserves the right to modify its products, the
technical specifications and installation instructions
without notice.
IMPORTANT NOTES
DISCLAIMER
• Please make sure that you have read and under-
stood all the safety information in this installation
guide be fore installing and operating the modules.
• Please observe all local, regional, national, and
international legal provisions, guidelines, stan-
dards, and regu lations, as well as the guidelines
on work safety from the employer’s liability insur-
ance associations.
Assembly, installation, and initial operation of the
modules requires expert knowledge and must
only be car ried out by qualified and authorized
professionals.
The modules must be checked for mechanical in-
tegrity before installation. Damaged modules must
not be installed.
DAS Energy PV modules meet the requirements ac-
cording to IEC 6215 and IEC 61730 (application class
A, protection class II). Modules of this application
class can be used in systems operated with more
than 50 V DC in generally accessible environments.
The modules almost produce full voltage also un-
der bad lighting conditions, even when they are
not connect ed to an electric current, i.e. caution is
always advised during installation with regard to
electrical faults e.g. short circuits.
The real output power produced by the modules
can be above the specified nominal power. The giv-
en nomi nal power is determined according to indus-
try standard at 1,000 W/m² radiation intensity and
25 °C solar cell temperature. In practical operation
the current intensity, voltage and resulting power
produced by the module can increase as a result of
colder ambient temperatures or the reflection from
snow, water, or other reflec tive surfaces.
Avoid focusing light and directing it onto the module.
Only use devices, connectors and cables which are
suitable for use with photovoltaic systems.
Please observe all safety measures and instruc-
tions for other components used.
2 General information