Dantherm 3500, Руководство по установке

Страница: 22 / 36

22
EN
How to set up fire/ smoke
alarm:
Connect the smoke detector to the digital input 1.
Ensure that the smoke detector has a dry contact.
If there is voltage at the digital input, the CC0 controller will be damaged.
When the smoke detector gives input the DC Air Conditioner will stop
Digital 1 and 2 is pre-set to NO, but can be changed to NC. See below.
How to change NO to NC or
vice versa:
Put in an empty SD card and the present configuration file will be downloaded.
Open the config file by wordpad
Go to section CONTROL Configurations No:
16.
Alarm NO/NC Type [ALtype] [0/1]:
1
17. Alarm1 delay sec [Alm Dly] [0-100]: 10
18. Dig.1 NO/NC Type [Dig1] [0/1]: 0
19. Dig.2 NO/NC Type [Dig2] [0/1]: 0
Change the marked 1 to 0 for changing to NO
Change the marked 0 to 1 for changing to NC
Save the change and put the SD card into the CC0 controller, and the controller will
automatically update the new Config file.
How to install a hot spot
sensor:
Be sure to have the temperature sensor from the accessory list and connect to the CC0 pin 8 & 9
For set up the hot spot sensor at the controller, put in an empty SD card and the present
configuration file will be downloaded.
Open the config file using Wordpad.
Go to section CONTROL Configurations No:
10.
Shelter Temp(RA/HS/BOTH) [STsel] [0-2]:
0
Change the marked 0 with 1 for using the hot spot sensor as cooling reference or 2 for using
both hotspot or the room temperature sensor at the indoor Unit as reference, The highest value
will be used for determining cooling.
Save the change and put the SD card into the CC0 controller, and the controller will
automatically update the new Config file.
Modifying the Configuration file