Dantherm 3500, Руководство по установке

Страница: 19 / 36

19
EN
Step down Enter Step up
Menu structure and
navigation.
Step up/down to jump through menues, end.
Enter to select the parameter to read or change
Step Action Display
Hibernate mode shows the actual room tempereature.
After 3 minutes without activity on the keys, the controller exits any menu and
shows this. Use up/down to select menu point below
Cooling setpoint
parameter Press enter for 2 seconds to change value. Enter
to save.
Heater setpoint
parameter Press enter for 2 seconds to change value. Enter
to save.
Note: Heater is not installed in this
product
Operation error list.
See list below. Press enter for 2 seconds to change reading to
see if more errors are present simultaneously.
Override test.
This will run a
series of tests.
See list on
next page. Press enter for 2 seconds to start test cycle. The
test steps will increase automatically by one
after 60 seconds or changed manually using up/
down.
If it is left idle, the test will auto disable after 30
minutes.
Alarm mode Via onboard navigation keys and display, alarm mode can be initiated. Can be used for service
purpose, and fault finding.
Press up/down key, until “err” is visible in display. Now press enter.
By use of up/down key, it is now possible to toggle between error codes.
Error codes shown in display, are masked error codes, related to which errors/alarms that are
mapped to the alarm relay output.
See section about controller configuration.
Operation, continued