8
S
S
PECIFICATIONS
PECIFICATIONS
HEATING SPECIFICATIONS
DIMENSIONS
Product subject to
Change without notice.
ELECTRICAL SPECIFICATIONS
Electrical Rating
= 115 Volts 60 HZ 2.0 Amps
Watts (operational)
= 175 (approximately)
Watts (optional igniter)
= 475 (approximately)
A voltage surge protector or ground fault outlet is required for this unit. The warranty on the circuit
board will be voided if surge protection is not installed before operating this unit.
If power outages or disturbances are a concern, you may wish to purchase a gas powered generator,
solar or battery back-up system. Ensure that it is a “Positive” sign wave and a minimum 1000 watts
continual.
EPA COMPLIANCE
This heater is exempt from EPA Phase II requirements, but has been tested for emissions using EPA test
methods by Warnock Hersey , US. Pellet appliances that are designed with the combustion air supply
exceeding 35:1 (by ratio) are exempt from EPA regulations.
Approx. Heating capacity (sq. feet) *
800 – 2,000
Approx. Fuel burn rate per hour **
1.5 – 5 lbs
Hopper Capacity - Bay View Freestanding
60 lbs
Approx. Burn time at lowest setting
48 hrs
Hopper Capacity – Bay View Insert / Built-in
40—60 lbs.
Approx. Burn time at lowest setting
27-48
Hopper Capacity - Freestanding Step Top
90 lbs
Approx. Burn time at lowest setting
65 hrs
Hopper Capacity— Classic Insert / Built-in
40 lbs.
Approx. Burn time at lowest setting
27 hrs
Glow Boy Pellet & Biomass
www.glowboystoves.com 8
24”
32 ½”
24”
18 3/4”
+
+
Shroud 1”
+
+
24”
6 1/2”
7 3/4”
8 1/4”
3 ½”
Exhaust
Air Inlet
8 1/4”
Air Inlet
12 3/4”
6 1/2”
Exhaust
24 3/4”
24”
24 3/4”
12 1/4”
10 3/4”
+
+
24”
8 1/4”
Air Inlet
17 1/4”
12 3/4”
6 1/2”
Exhaust
24 3/4”
30”
24”
+
Shroud 1”
8 1/4”
Air Inlet
17”
12 3/4”
Exhaust
26”
12 1/4”
10 3/4”
+
25”
Air Inlet
7”
Exhaust
+
+
Exhaust
26”
+
24”
6 ½”
Exhaust
+
Air Inlet
8 1/4”
7 3/4”
3 ½”
24”
Bay View Freestanding
Bay View Insert / Built-In
Step Top Freestanding
Classic Insert / Built-In
19”
-
23”
Adjustable
Hopper
¹ Heating capacity will vary depending on floor plan layout of your home, degree of insulation, and
the outside temperature. Fuel size, quality, density and moisture level will also have an effect.
¹¹ Pellet size may affect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as
much as 20%. Use PFI listed fuel for best results, pelletheat.org for further information.
