6. Wall Mounting Bracket
– Use the bracket to mount the camera on a wall or other flat surfaces.
7. AC Adaptor Jack
– Plug the AC adaptor to the jack for camera’s power supply.
8. Pair Button
– The pair button is located on the back of the camera, it is used to pair the camera with
receiver.
Note:
This camera includes an Auto Mechanical IR Cut Filter. When the camera changes between day
mode
and night vision mode, an audible clicking noise may be heard coming from the camera. This
clicking is
normal, and indicates that the camera filter is working.
Camera Installation
Before you install the camera, carefully plan where and how it will be positioned, and where you will
route the cable that connects the camera to the power adaptor.
Before starting permanent installation, verify its performance by observing the image on the receiver
when camera is positioned in the same location/position where it will be permanently installed and the
receiver is placed in the location where it will be used most of the time.
Installation Warnings
·
Aim the camera(s) to best optimize the viewing area: Select a location for the camera that provides a
clear view of the area you want to monitor, which is free from dust, and is not in line-of-sight to a strong
light source or direct sunlight.
·
Avoid installing the cameras where there are thick walls, or obstructions between the Cameras and the
Receiver.
·
Select a location for the camera that has an ambient temperature between 14
°
F~104
°
F(-10
°
C~40
°
C)
·
Not intended for submersion in water. For outdoor use, installation in a sheltered location is
recommended
Night Vision
This camera has built-in IR LEDs, which provides the camera with the ability to view images in no/low
light conditions.
Mounting Positions
You may mount your camera on a wall, ceiling, or counter. See the images below for recommended
configurations of the camera stand and antenna.
