2. Download the latest firmware and transfer it to the root folder on the micro SD card.
3. Once the transfer is complete, insert the micro SD card into the card slot on the receiver.
4. Press
, then move the joystick to select Settings.
5. Select
Firmware Upgrade
and push the joystick to confirm.
6. Select
From SD Card
, then selected
Yes.
The system takes a few moments to install the latest
firmware.
7. After upgrading the new firmware, the monitor will automatically reboot .
CAUTION: During upgrading , do not plug out power during upgrading.
-Network:
Configure the receiver’s IP address (advanced),
view network information, or reset your remote access
password.
1. Networking setting: IP Addressing Options,to select the
Static IP and Dynamic IP
CAUTION:
This section is for advanced users only.
Note
•
Dynamic IP addressing is enabled by default.
•
A static IP address is not required for remote access to
the system.
•
You may have to configure your router settings if the
DHCP server is enabled.
2.Information:Set up the Static IP address and Dynamic IP
on/off, display the current network information(IP State, IP
Address, default gateway, MAC address ,UID as pasted on
the back of monitor ,etc).
3. Reset password:
Reset the password of remote access by
000000
5.2 Detect
Separately to Set each Camera’s motion detect sensitivity
(High, Medium, Low, Off), move the joystick to select the
level of sensitivity then Push the joystick to confirm the
adjustment.(Default Low)
