2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
1.
2.
Wait for the necessary discharge time to elapse.
Disconnect any cables connected to the X3, X4, or X5 ports on both ISD 510/DSD 510 servo drives for easier access to the
loop cable.
Loosen the threaded rings of the loop cable connectors on both servo drives.
Disconnect the loop cable from the servo drives.
10.7.3.2 Replacing the Loop Cable
Replace the loop cable with a cable of identical type and length. See the
VLT® Servo Drive System ISD 510, DSD 510, MSD 510
(VLT® Flexmotion
™
) Design Guide
for part numbers.
10.7.3.3 Connecting the Loop Cable
Connect the male connector of the loop cable to the female connector on the servo drive.
Connect the female connector of the loop cable to the male connector on the adjacent servo drive.
Turn the threaded rings hand tight on both servo drives.
Ensure that there is no mechanical tension on the cables.
Tighten the threaded rings of the connectors on both servo drives.
Reconnect any cables that were connected to the X3, X4, or X5 ports on both servo drives.
10.8 Fuse Replacement in Decentral Access Module (DAM 510)
If a single fuse blows, replace all the fuses with fuses from the same batch (fuse CAT number 5012006.25, SIBA).
Procedure
Remove the screws [1] and remove the cover.
1
e
3
0
b
g
8
0
0
.1
0
Illustration 114: Opening the Cover on DAM 510
Use a screwdriver to remove the fuses and replace them with the same number of identical type fuses (see
).
AQ262449648484en-000101 / 175R1135 | 181
Danfoss A/S © 2020.08
Maintenance, Decomissioning, and
Disposal
VLT® Servo Drive System ISD 510/DSD 510
Operating Guide
