VLT® 5000 Crane
Status word [Hex]
gives the status word sent
via the serial communication port in Hex code
from the frequency converter.
Brake power/2 min. [KW]
states the brake
power transferred to an external brake resistor.
The mean power is calculated continuously
for the latest 120 seconds.
It is assumed that a resistor value has been
entered in parameter 401.
Brake power/sec. [kW]
states the present brake
power transferred to an external brake resistor.
Stated as an instantaneous value.
It is assumed that a resistor value has been
entered in parameter 401.
Heat sink temp. [°C]
states the present heat sink
temperature of the frequency converter. The cut-out
limit is 90 ± 5°C; cutting back in occurs at 60 ± 5°C.
Alarm word [Hex]
indicates one or several
alarms in a Hex code.
Control word. [Hex]
indicates the control
word for the frequency converter. See Serial
communication in Appendix.
Warning word [Hex]
indicates one or more
warnings in a Hex code.
010 DISPLAY LINE 1.1
Value:
See parameter 009 for choices.
✭
Reference [%]
Function:
This parameter enables a choice of the first of three data
values to be shown on the display, line 1, position 1.
For display read-outs, press the [DIS-
PLAY/STATUS] button.
011 DISPLAY LINE 1.2
Value:
See parameter 009 for choices
✭
Motor current [A]
Function:
This parameter enables a choice of the second
of the three data values to be shown on the
display, line 1, position 2.
For Display read-outs, press the [DIS-
PLAY/STATUS] button.
012 DISPLAY LINE 1.3
Value:
See parameter 009 for choices
✭
Power [kW]
Function:
This parameter enables a choice of the third of the three
data values to be shown on the display, line 1, position 3.
Display read-outs are made by pressing the
[DISPLAY/STATUS] button.
014 LCP STOP
Value:
Not possible (DISABLE)
[0]
✭
Possible (ENABLE)
[1]
Function:
This parameter disables/enables the local stop function
in question from the control panel.
This key is used when parameter 002 has been
set for
Remote control
[0] or
Local
[1].
Description of choice:
If
Disable
[0] is selected in this parameter, the
[STOP] key will be inactive.
NB!:
If
Enable
is selected, the [STOP] key
overrules all Start commands.
015 LCP JOGGING
Value:
✭
Not possible (DISABLE)
[0]
Possible (ENABLE)
[1]
Function:
In this parameter, the jog function can be
enabled/disabled on the control panel.
The key can be used when parameter 002 has been
set for
Remote control [0]
or
Local [1]
.
NB!:
LCP jogging is only available when
running in FC profile!
Description of choice:
If
Disable
[0] is selected in this parameter, the
[JOG] key will be inactive.
✭
= factory setting. () = display text [] = value for use in communication via serial communication port
MG.50.N4.02 - VLT is a registered Danfoss trademark
52
