Danfoss VLT 5000 Series, Руководство по эксплуатации

Страница: 28 / 63

VLT® 5000/ 5000 FLUX/ 6000 HVAC/
8000 AQUA PROFIBUS
Control word/Status
word
■
Control word according to fc standard
Control word in FC profile (parameter 512 = FC Drive)
The Control word is used to send commands from
a master (e.g. a PC) to a slave.
Bit Bit = 0 Bit =1
00 Reference value
external selection lsb
01 Reference value
external selection
msb
02 DC brake Ramp
03 Freewheel No freewheel
04 Quick stop Ramp
05 Holding Ramp possible
06 Ramp stop Start
07 Without function Reset
08 Without function Jog
09 Ramp 1 Ramp 2
10 Data not valid Valid
11 Without function Relay 01 active
12 Without function Relay 04 active
13 Parameter setup
selection lsb
14 Parameter setup
selection msb
15 Without function Reversion
Bit 00/01
The bits 00 and 01 are used to choose between the
four preprogrammed reference values (parameters
215-218) according to the following table:
Progr. ref. val. Parameter Bit 01 Bit 02
1 215 0 0
2 216 0 1
3 217 1 0
4 218 1 1
Bit 02, DC brake
Bit 02 = "0" leads to direct voltage braking and
stop. Braking current and duration are set in
parameter 125 and 126.
Bit 02 = "1" results in Ramp.
Bit 08, Activation of the fixed speed in parameter 213
In the case of bit 08 = "0", the fixed speed
will not be activated.
In the case of bit 08 = "1", the motor runs
at the fixed speed.
Bit 09, Ramp selection 1/2
In the case of bit 09 = "0", ramp 1 is active
(parameter 207/208).
In the case of bit 09 = "1", ramp 2 is active
(parameter 209/210).
Bit 11, Relay 01
Bit 11 = "0": Relay 01 is not activated.
Bit 11 = "1": Relay 01 is activated, on the pre-condition
that Control word bit was selected in parameter 323.
Bit 12, Relay 04
Bit 12 = "0": Relay 04 is not activated.
Bit 12 = "1": Relay 04 is activated, on the pre-condition
that Control word bit was selected in parameter 326.
NB!:
The description of the other bits can
be found in the section "Control word
according to Profidrive".
MG.90.G1.02 - VLT is a registered Danfoss trademark
27