Dane Technologies, Inc.
QuicKART 2000 Series
Service Manual
7105 Northland Terrace, Minneapolis, MN 55428 / 888-544-7779 / 763-544-7779 / Fax 763-544-4234
www.danetechnologies.com
970-011 Rev. 3/1/06
37
REMOTE CONTROL: BATTERY CHANGING
Refer to Diagrams on page 38.
1.
The remote control is to be taken apart only when the batteries need replacing.
There are no adjustments or switches inside the module. As long as the small light
on the remote panel lights-up the battery does not need replacing.
2.
Before opening the remote turn off the QuicKART that had been using this remote.
If another remote is being used by this QuicKART it is OK to proceed.
3.
To open remote control, place the control panel face down on a table top and use
a medium size Phillips screw driver to remove the two (2) screws from the corners
of the remote’s back cover.
4.
After the screws are removed, leave the remote face down and remove the back
cover.
5.
To replace the batteries, take out the old batteries and replace them with new,
ensuring that the new batteries are inserted as diagramed inside the battery
compartment.
6.
Properly dispose of the old batteries in an environmentally correct depository.
7.
Examine the inside of the remote for any signs of condensation or water. If signs
of moisture are present, allow the compartment to dry fully before replacing the
back.
8.
Before replacing the back, ensure that the gray rectangular gasket around the
edge of the battery compartment is in good condition. If the gasket is damaged,
return the remote to Dane Technologies for repair.
9.
Also, ensure that the red and black wires leading away from the battery terminals
and the black wire at the opposite end of the remote are intact. If they are broken,
return the remote to Dane for repair
10. The QuicKART should be
“off”.
Before replacing the back, ensure the panel light
comes on when any one of the function buttons is pressed.
11. Replace the back with the two Phillips screws.
12. Reprogram the remote control as described on page 38.
