Getting Started
Danaher Motion Kollmorgen
1.2.1.
UNPACKING
1.
Check the package and contents upon arrival. If the packaging was
damaged upon delivery, contact the shipping carrier prior to removing
the components from the container.
2.
Check the shipping invoice against the purchase order to make sure
that the factory has sent all the ordered components. If a discrepancy
exists, contact the factory immediately.
3.
Remove all the packing material and equipment from the shipping
container. Exercise caution when unpacking the components to be
sure that smaller components are not accidentally discarded.
NOTE
Do not dispose of the packing material until all the
components of the packing list have been accounted
for and verified.
1.2.2.
POSITIONER QUESTIONS
Regardless of what positioner is used, it must be configured to operate with
the SERVO
STAR
software. The following questions need to be answered
before installing the SERVO
STAR
. Write this information down as the
questions are answered.
1.
Is the positioner command output single ended?
2.
Is the enable line from the positioner to C3, pin 8 an active low to
enable the drive?
3.
Does the positioner enable signal have an open collector output?
1.2.3.
MOTIONLINK QUESTIONS
These questions concern the configuration stage and type of devices
installed to complete the system, Write this information down as the
questions are answered.
1.
Linear motortype and model number?
2.
Encodertype and resolution (lines per millimeter)?
3.
External or internal logic multipliers?
4.
Is there a Hall effect module?
5.
Is there one index pulse, multiple index pulses, or no index pulse
on the scale?
6.
Is there a thermistor in the motor?
7.
Are there limit switches?
8.
Is AC input power 110 or 220 volts?
2 05/07
M-LN-016-0702
Rev
D
Содержание Kollmorgen SERVOSTAR C Series
